Electrical Engineering Archive: Questions from June 07, 2023
-
There is a transposed transmission line 70km long with two parallel circuits of one conductor per phase with the layout as shown in figure 1. The conductor used is Condor. The line feeds a 70 mw load,
Se tiene una línea de transmisión transpuesta de \( 70 \mathrm{Km} \) de longitud con dos circuitos paralelos de un conductor por fase con la disposición como se muestra en la figura 1. El conducto2 answers -
A three-phase line is made up of two parallel circuits with two conductors per phase spaced 45 cm apart, as shown in the figure. the conductor is BLUEJAY, with line transposed to 1/3 and 2/3 of the li
Una línea trifásica está compuesta de dos circuitos paralelos con dos conductores por fase espaciados en \( 45 \mathrm{~cm} \), como se muestra la figura. El conductor es BLUEJAY, con línea transp0 answers -
there is a transposed transmission line of 180 KM of two parallel circuits of one conductor per phase with the arrangement as shown in figure 1, the conductor is BLUEJAY. The transmission line is 230
Se tiene una línea de transmisión transpuesta de \( 180 \mathrm{Km} \) de dos circuitos paralelos de un conductor por fase con la disposición como se muestra en la figura 1, el conductor es Bluejay2 answers -
0 answers
-
2 answers
-
2. Un alambre de aluminio con un seccion transversal de perfil cuadradado y con apenes \( 7.875 \times 10^{-2} \) in de lado, lleva una corriente de \( 8.00 \mathrm{~A} \). La denaidad del aluminio es2 answers -
5. Un cable de cobre debe diseñarse para transportar una corriente de 300.0 A con una pérdida de potencia de sb́lo \( 20.0 \mathrm{~W} / \mathrm{m} \). ¿Cuál es el radio requerido del cable de co2 answers -
8. Una bobina de 1200 espirus de alambre de cobre de calibre \( 18(0.04 \) in de dímetro del alambre) tiene \( 20 \mathrm{~cm} \) de díimetro (de la bob/ns), se introduce a un espacio donde el campo2 answers -
2 answers
-
2. Un alambre de aluminio con un sección transversal de perfil cuadradado y con apenas \( 7.875 \times 10^{-2} \) in de lado, lleva una corriente de \( 8.00 \mathrm{~A} \). La densidad del aluminio e2 answers -
0 answers
-
2 answers
-
2 answers
-
2 answers
-
2 answers
-
0 answers
-
2 answers
-
0 answers
-
2 answers
-
2 answers
-
0 answers
-
2 answers
-
2 answers
-
2 answers
-
0 answers
-
2 answers
-
2 answers
-
2 answers
-
2 answers
-
0 answers
-
2 answers
-
2 answers
-
0 answers
-
2 answers
-
2 answers
-
1 answer
-
1 answer
-
0 answers
-
2 answers
-
2 answers
-
2 answers
-
2 answers
-
0 answers
-
w=7
4. Utilizando el Análisis de Kirchhoff, calcula los voltajes y corrientes de cada uno de los elementos de los circuitos de la figura 3 considerando que: (20 pts) \( \boldsymbol{w}=5+ \) último digit2 answers -
La estructura magnética de la figura está fabricada con dos tipos de materiales, cuyas curvas de magnetización vienen expresadas por las ecuaciones: \[ B=\frac{1.1 H_{1}}{5000+H_{1}}, \quad B=\frac2 answers -
El núcleo esta hecho de un material cuya curva de magnetización viene dada por: \[ B=\frac{1.6 H}{75+H} \quad B: \text { Teslas; } H: \mathrm{Av} / \mathrm{m} \]2 answers -
Un circuito magnético tiene una sección uniforme de \( 8 \mathrm{~cm} 2 \) y una longitud magnética media igual a 0,3 metros. Si la curva de magnetizaciбn del material viene expresada aproximadame2 answers -
R1=2 ohms R2=3 ohms R3=6 ohms
3. Utiliando el Principio de Superposición, calcula las corrientes, voltajes y potencins de los elementos del circuito de la figura 2 considerando los valores en ich \( (10 \) pts) \( R 1 \) = numero2 answers -
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
Un circuito magnético tiene una sección uniforme de \( 8 \mathrm{~cm} 2 \) y una longitud magnética media igual a 0,3 metros. Si la curva de magnetizaciбn del material viene expresada aproximadame2 answers -
2 answers
-
2 answers
-
2 answers
-
0 answers
-
2 answers
-
2 answers
-
2 answers
-
2 answers
-
2 answers
-
2 answers
-
2 answers
-
2 answers
-
Las terminaciónes a conciderar son A y B de la parte superior del circuito Cb solo es una terminal extra
Usando_ \( \omega=1000 \mathrm{rad} / \mathrm{s} \), encuentre la impedancia equivalente vista desde las terminales A y B (puede usar las funciones de Matlab proporcionadas para hacer los cálculos)2 answers -
\[ \frac{v_{0}}{v_{1}}=-\left(1+\frac{R_{3}}{R_{4}}\right)\left(\frac{R_{1}}{R_{2}}\right) \] Para obtener la ganancia, recuerda el análisis de nodos que hemos hecho en las clases anteriores. Realiza2 answers -
Una línea de transmisión de \( \mathrm{Zo}=60 \), con una longitud de \( 125,2[\mathrm{~m}] \), opera a fe \( =935 \) [Mhz] con una constante de atenuación de \( 9 \times 10^{-3}[\mathrm{~Np} / \ma2 answers -
Dada una cavidad resonante rellena de un material sin pérdidas con constante dieléctrica 6,7, con las medidas a=7,7 \( \mathrm{cm} \), \( b=9,3 \mathrm{~cm}, c=9,6 \mathrm{~cm} \), calcule la frecue2 answers -
Diseñe una guía de ondas rectangular rellena de aire, hecha en cobre, para que trabaje en el modo dominante TE10, en el rango de frecuencias 3,9 Ghz y 9,7 Ghz, manteniendo un margen del 14% de segur
Diseñe una guia de ondas rectangular rellena de aire, hecha en cobre, para que trabaje en el modo dominante TE10, en el rango de frecuencias 3,9 Ghz y \( 9.7 \mathrm{Ghz} \), manteniendo un margen de2 answers -
29.6 - GALC Una bobina de \( 4.00 \mathrm{~cm} \) de radio tiene 500 espiras, y está colocada en un campo magnético uniforme que varía con el tiempo de acuerdo con \( B=(0.0120 \mathrm{~T} / \mathr2 answers -
29.10 - Una bobina rectangular con embobinado compacto de 80 espiras mide \( 25.0 \times 40.0 \mathrm{~cm} \). El plano de la bobina gira desde una posición donde forma un ángulo de \( 37.0^{\circ}0 answers -
On the servo shown there are two 12 kilohm potentiometers with 3 full turns. The voltage source that powers the position detector is 9 V. The input amplifier to the motor is an inverting amplifier wit
En el servomecanismo mostrado se tienen dos potenciómetros de 12 kiloohmios de 3 vueltas completas. La fuente de voltaje que alimenta el detector de posición es de \( 9 \mathrm{~V} \). El amplificad0 answers -
Calculate the transfer function of the following figure. a) Total inertia (10% of the grade) b) Total viscous coefficient (10% of the grade) c) Total elastic coefficient (10% of the grade) d) Equatio
Calcular la función de transferencia \( \frac{\theta_{3}(s)}{T(s)} \) de la siguiente figura. Se calificará a) Inercia total (10\% de la nota) b) Coeficiente viscoso total (10\% de la nota) c) Coefi2 answers -
2 answers
-
2 answers
-
2 answers