Mechanical Engineering Archive: Questions from November 22, 2022
-
Hints: Its the same
Exercise. The figure shows a pendulum consisting of a thin bar and a disc. The bar has a mass \( m b \) and a length \( L \). The disk has a mass \( m d \) and radius \( R \) and is located at \( d \)1 answer -
1. (15) Determine las reacciones de la cercha que se muestra. El soporte en \( A \) es "pin" y en E es un "roller". Dibuje el diagrama de cuerpo libre.2 answers -
The figure shows a rigid body that is supported at A and E by a pin. Point C is pinned (hinge), where part C-D-E has no load applied. Determine the reactions at the supports. Draw the free body diagra
2. (20) La figura muestra un cuerpo rigido que está apoyado en A y en E por un "pin". El punto C este articulado (hinge), donde la parte C-D-E no tiene carga aplicada. Determine las reacciones en los1 answer -
Los engranes \( \mathrm{C} \) y \( \mathrm{D} \), con un ángulo de presión \( \phi=20^{\circ} \), están montados sobre el eje que se muestra en la Figura. La fuerza tangencial en el engrane \( C \)0 answers -
Consider the following analog PI control equation Obtain the equivalent diferences equation of the controller by the rectangular integration technique (fback
Prob. \#3. (30 puntos) Considere la siguiente ecuación de control PI analógica: \[ G(s)=\frac{M(s)}{E(s)}=5\left(1+\frac{4}{s}\right) \] Obtenga la ecuación de diferencias equivalente de dicho cont2 answers -
0 answers
-
Determine the internal normal force, shear force, and bending moment at points E and F of the arrangement shown in the figure.
1. Determine la fuerza normal interna, la fuerza cortante y el momento fexionante en los puntos E y F del arreglo que se muestra en la figura. ( 33 pts.)2 answers -
Determine the internal normal force, the shear force, and the bending moment in sections a-a and b-b of the structure shown in the figure.
2. 1. Determine la fuerza normal interna, la fuerza cortante y el momento flexionante en las secciones a-a y b\( b \) de la estructura que se muestra en la figura. (33 pts.)2 answers -
Determine the equations and draw the shear force and bending moment diagrams of the beam that is shown in the figure.
3. Determine las ecuaciones y dibuje los diagramas de fuerza cortante y momento flexionante de la viga que se muestra en la figura. (34 pts.)2 answers -
II PARTE: PROBLEMAS PROPUESTOS. Resuelva el siguiente problema en total orden, nitidez y lo más exacto posible. El sistema en la línea de distribución de querosene a \( 15.6^{\circ} \mathrm{C}( \)0 answers