Mechanical Engineering Archive: Questions from June 16, 2022
-
The gear ratio shown is to transmit 10 horsepower (66,000 lb in/s) from its input, which is rotating at a speed of 1200 revolutions per minute. You must increase the torque received at your input shaf
La relacion de engranes mostrada debe transmitir 10 caballos de fuerza (66000 lb in/s) desde su entrada, la cual está rotando a una velocidad de 1200 revoluciones por minuto. Debe incrementar el torq1 answer -
The gear ratio shown must transmit 10 horsepower (66,000 lb in/s) from its input, which is rotating at a speed of 1200 revolutions per minute. You must increase the torque received at your input shaft
La relacion de engranes mostrada debe transmitir 10 caballos de fuerza (66000 lb in/s) desde su entrada, la cual está rotando a una velocidad de 1200 revoluciones por minuto. Debe incrementar el torq1 answer -
The gear transmission shown in the figure should have a torque increase ratio of 16:1. For this purpose, spur gears with a 20° pressure angle and full length teeth should be used. The input and outpu
La transmisión de engranes mostrada en la figura debe tener una relación de incremento de torque de 16:1. Para tel efecto deben usarse engranes rectos con un ángulo de presión de 20° y dientes de1 answer -
Shaft a rotates at a speed of 541 rpm in the direction shown. Find the magnitude of the rotational speed of the d-axis. Write your answer in rpm.
El eje a rota a una velocidad de 541 rpm en la dirección mostrada. Encuentra la magnitud de la velocidad de rotación del eje d. Escribe tu respuesta en rpm. 20T, = 30° RH 8T, = 60° RH 3 5 407 17T,1 answer -
a force of 288n is exerted on a wire rolled around a 150mm drum (millimeters) in diameter. what is the timing of torsion produced approximately at center of the drum? a girl weighs 315N and a bo
6. Se ejerce una fuerza de 288 N sobre un cable enrollado alrededor de un tambor de 150 mm (milimetros) de diámetro. ¿Cuál es el momento de torsión producido aproximadamente al centro del tambor?1 answer