Electrical Engineering Archive: Questions from December 05, 2023
-
0 answers
-
Siempre que se use retroalimentación, se reduce la ganancia en comparación con la ganancia del amplificador sin retroalimentación. a. cierto b. falso La salida de un oscilador Colpitts ideal es un1 answer -
Lo especial de los osciladores es que no se necesita ninguna fuente ac o dc conectada al oscilador para que en la salida se produzca una señal ac. a. cierto b. falso En la práctica, para diseñar u1 answer -
Al añadir retroalimentación positiva a un amplíficador, la ganancia neta: a. disminuye y es estable b. disminuye y es inestable c. aumenta y es inestable d. aumenta y es estable La salida de un os1 answer -
Al añadir retroalimentación positiva a un amplíficador, la ganancia neta: a. disminuye y es estable b. dismunye y es inestable c. aumenta y es inestable d. aumenta y es estable La salida de un osc1 answer -
Un oscilador es a. un generador de señales no-periódicas b. un generador de señales periódicas c. un filtro al que se le ajusta la frecuencia d. un filtro al que se le ajusta la ganancia e. un gen1 answer -
Determine the parameters [h] for the two-port network in the figure.
1.- Determine los parámetros [ \( \mathrm{h} \) ] para la red de dos puertos de la figura.2 answers -
For the two-port network in the figure where its impedance parameters are: determine: Zent, Zsal and the power delivered by the source
\[ [z]=\left[\begin{array}{cc} 80 & 120 \\ 160 & 240 \end{array}\right] \Omega \] determine: Zent, Zsal y la potencia entregada por la fuente. \( (30 \%) \)1 answer -
Determine the admittance parameters of the network C shown in the figure. nConsider the following parameters for each subnet
3.- Determinar los parámetros de admitancia de la red \( \mathrm{C} \) mostrada en la figura. Considere los siguientes parámetros para cada subred (20\%): Subred A: \( \left[h_{A}\right]=\left[\begi1 answer -
1 answer
-
1 answer
-
1 answer
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
1 answer
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
1 answer
-
1 answer
-
0 answers
-
1 answer
-
0 answers
-
1 answer
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
0 answers
-
1 answer
-
For the following circuit the input signal Eent is a triangular wave of 5V peak at a frequency of 1 Hz. 1. Plot the output for 2 seconds. 2. Vo vs Vi chart.
Para el siguiente circuito la señal de entrada Eent es una onda triangular de \( 5 \mathrm{~V} \) de pico a una frecuencia de \( 1 \mathrm{~Hz} \). 1. Grafique la salida para 2 segundos. 2. Grafique1 answer -
For the next circuit. 1. Vi and Vo graph as a function of time. 2. Vo vs Vi Chart
Para el siguiente circuito. 1. Grafique Vi y Vo en función del tiempo. 2. Grafique \( \mathrm{Vo} \) vs \( \mathrm{Vi} \)0 answers -
B-6-15. Determine los valores de \( K, T_{1} \) y \( T_{2} \) del sistema de la Figura 6-105 tales que los polos dominantes en lazo cerrado tengan el factor de amortiguamiento relativo \( \zeta=0.5 \)0 answers -
B-6-12. Dibuje los diagramas de los lugares de las raices para el sistema de fase no mínima de las Figuras 6-102(a) y (b), respectivamente. Figura 6-102. (a) y (b) Sistemas de fase no mínima.0 answers -
1 answer
-
1 answer
-
0 answers
-
0 answers
-
1 answer
-
0 answers
-
1 answer
-
0 answers
-
1 answer
-
1 answer
-
0 answers
-
2. Un sistema esta descrito mediante la siguiente ecuación diferencial \[ \frac{d^{2} y(t)}{d t^{2}}+5 \frac{d y(t)}{d t}+6 y(t)=\frac{d f(t)}{d t}+f \] donde la entrada es \( f(t)=2 e^{-t} u(t) \) c1 answer -
1 answer
-
0 answers
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1, 13) Ottijan el terrema de Therrenir pas calcular la corrénts par lu Carga en el circrito 1.19 paro cado una de las Sigüente resistersear de cargo: \( 0.1 \mathrm{k} \Omega, 2 \mathrm{k} \Omega, 30 answers -
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
1 answer
-
0 answers
-
1 answer
-
1 answer