Civil Engineering Archive: Questions from May 16, 2022
-
Analize and view the following Transcoord sub routine to answer the questions found below: Using the COORDINATES in the original system of points 2 and 3 calculate the distance between them. Then usin
Descripción sm2 smi sm4 Coordenadas en el sistema original: Ingrese los puntos de los cuales conoce las coordenadas en el sistema a transformarse. Punto Coordenada Y Coordenada X Elevación 2 1005.051 answer -
Analize and view the screen that is generated in the TransCoord subroutine. Then Answer the questions found below What are the parameters, what are they called and what values do they have? What error
Descripción sm2 smi sm4 Coordenadas en el sistema original: Ingrese los puntos de los cuales conoce las coordenadas en el sistema a transformarse. Punto Coordenada Y Coordenada X Elevación 2 1005.051 answer -
Problem 1. If the reactions of the truss shown in Figure 1 are Ax= 5 kN (left), Ay = 3.5 kN (up) and Ey = 6.5 kN (up): A. Show that the system is statically determinate. B. Identify elements with forc
Problema 1. Si las reacciones de la cercha mostrada en la Figura 1 son Ax= 5 kN (izquierda), Ay = 3.5 kN (arriba) y Ey = 6.5 kN (arriba): A. Demuestre que el sistema es estáticamente determinado. B.1 answer -
Problem 2. Apply the Method of Sections on the truss shown in Figure 2 to find the FAB, FBD, FEG and FGH forces. HINT: The reaction Ey = 8.33 kN (above). you will need to perform two cuts (1-1 and 2-2
Problema 2. Aplique el Método de Secciones en la cercha mostrada en la Figura 2 para hallar las fuerzas FAB, FBo, Fe y FGH. AYUDA: La reacción Ey = 8.33 kN (arriba). Necesitarás realizar dos cortes1 answer -
HELP
1. UNA VIGA SEGÚN PRESENTADA, SOPORTA UNA CARGA PUNTUAL DE 10 KIPS A UNA DISTANCIA DE 10 FT DEL APOYO B YUNA DE 5 KIPS EN EL EXTREMO LIBRE. DETERMINE EL DESPLAZAMIENTO Y ROTACIÓN EN EL PUNTO C. (301 answer -
HELP S.O.S
3. DETERMINE LAS FUERZAS INTERNAS DE CADA UNO DE LOS MIEMBROS DE LA CERCHA. (20 PTS). BONO: POR EL MÉTODO DE SECCIÓN, DETERMINE LA FUERZA EN EL ELEMENTO BE. (10 PTS) 30 K 30 B 20 ft E D 20.11 20 2011 answer -
1 answer
-
1. Un sistema de bombeo tiene las siguientes características, f=0.015 longitud de la tubería = (2500 ft) diámetro de la tubería 6 in, perdidas menores de 0.5, la tubería es de cast iron, y la cur0 answers -
Longitud de la tubería entre el MH1 y el MH2 es 3m, de la MH2 a MH3 son 25m y las tuberías tienen una velocidad de 9(ft/seg).
Determine el caudal en cada Manhole como lo muestra la figura, deberá hacer el diseño para un periodo de retorno de 50 años. Tomaran como localización la casa de cada uno de ustedes. A С E a B1 answer -
1 answer